Publicaciones

• COUV

Trois expériences d'apprentissage par les problèmes

Jean-Paul Becar, Jean-Charles Canonne, Fabrice Robert, Eric Cartignies, Aurel Fratu, Mariana Fratu, Désiré Dauphin Rasolomampionona

Le projet : les pratiques en IUT, Contribution au chapitre IV- Articuler l’approche projet et le pilotage institutionnel, L’Harmattan, pp.106-110, 2016, 978-2-343-10803-2. ⟨hal-02508572⟩

• ART

EQUITAS: A tool-chain for functional safety and reliability improvement in automotive systems

Reda Nouacer, Manel Djemal, Smail Niar, Gilles Mouchard, Nicolas Rapin, Jean-Pierre Gallois, Philippe Fiani, François Chastrette, Arnault Lapitre, Toni Adriano, Bryan Mac-Eachen

To support advanced features such as hybrid engine control, intelligent energy management, and advanced driver assistance systems, automotive embedded systems must use advanced technologies. As a result, systems are becoming distributed and include dozens of Electronic Control Units (ECU). On the...

Microprocessors and Microsystems: Embedded Hardware Design , 2016, 47, pp.252-261. ⟨10.1016/j.micpro.2016.07.020⟩. ⟨cea-01845196⟩

• ART

Experimental Investigations on Oscillatory Couette Taylor Flow Wall Shear Stress Behavior using Electrochemical Technique: Low Modulation Effect

Emna Berrich, Fethi Aloui, Jack M Legrand

In the simplest and original case of study of the Taylor–Couette TC problems, the fluid is contained between a fixed outer cylinder and a concentric inner cylinder which rotates at constant angular velocity. Much of the works done has been concerned on steady rotating cylinder(s) i.e. rotating...

Journal of Applied Fluid Mechanics, 2016, 9 (1), pp.147-154. ⟨10.36884/jafm.9.SI1.26163⟩. ⟨hal-02545268⟩

• COMM

A thermal study of power cables cooling in tunnels

Fahd Boukrouche, Christophe Moreau, Souad Harmand, François Beaubert, Julien Pellé, Olivier Moreau

Power transmission through power cables installed in ventilated tunnels has been increasingly used worldwide and offers a complex thermal environment. Established correlations currently in use have been deduced from a non-fully developed turbulent flow. This paper details the experimental...

7th European Thermal-Sciences Conference (Eurotherm2016), Jun 2016, Cracovie, Poland. pp.032032, ⟨10.1088/1742-6596/745/3/032032⟩. ⟨hal-03439268⟩

• PROCEEDINGS

Service Orientation in Holonic and Multi-agent Manufacturing

Theodor Borangiu, Damien Trentesaux, André Thomas, Duncan Mcfarlane

Of interest are recent advances and on-going research in holonic and agent-based systems for manufacturing. Industrials are seeking for models and solutions that are not only able to provide efficient overall production performance, but also to face reactively a growing set of unpredicted events....

2016, Service Orientation in Holonic and Multi-agent Manufacturing, 978-3-319-30335-2. ⟨10.1007/978-3-319-30337-6⟩. ⟨hal-01425754⟩

• ART

Multiscale roughness analysis of engineering surfaces: A comparison of methods for the investigation of functional correlations

Gaëtan Le Goïc, Maxence Bigerelle, Serge Samper, Hugues Favrelière, Maurice Pillet

This study investigates the correlations between the topography of different damaged rough surfaces and process conditions. Several surfaces are measured and compared to determine if they can be discriminated. The analysis is performed by using Gaussian Filtering, Wavelet Transform and a more...

Mechanical Systems and Signal Processing, 2016, 66-67, pp.437-457. ⟨10.1016/j.ymssp.2015.05.029⟩. ⟨hal-01202891⟩

• ART

Experimental Study of Heat and Mass Transfer for Liquid Film Evaporation along a Vertical Plate Covered With a Porous Layer

Amine Terzi, Sadok Ben Jabrallah, Souad Harmand

In this paper, we realized an Experimental study of heat and mass transfer for liquid evaporation along a vertical plate covered with a porous layer. To develop this study, an experimental dispositive was realized. To highlight the effect of the addition of a porous layer on the phenomenon of...

Journal of Applied Fluid Mechanics, 2016, Selected papers from the 7thInternational Exergy, Energy and Environment Symposium, IEEE7-2015, 9 (Special issue 1), pp.113-120. ⟨10.36884/jafm.9.SI1.25821⟩. ⟨hal-03447185⟩

• COMM

The ConWip Production Control System: a Literature Review

Yann Jaegler, Patrick Burlat, Samir Lamouri

A growing body of literature dealing with ConWip has been observed during the past decade. Considering the current industrial challenges characterized by adaptability, product customization, shortened lead times and customer satisfaction, ConWip appears to be an effective and adapted production...

The International Conference on Information Systems, Logistics and Supply Chain (ILS International Conference) , KEDGE Business School in Bordeaux, Jun 2016, Bordeaux France. ⟨hal-01350666⟩

• ART

Local stability of discrete-time TS fuzzy systems

Zsofia Lendek, Jimmy Lauber

This paper considers local stability analysis of discrete-time Takagi-Sugeno fuzzy systems, for which classically in the TS literature only global stability is considered. Using a common quadratic and nonquadratic Lyapunov function, respectively, LMI conditions are developed to establish local...

IFAC-PapersOnLine, 2016, 49 (5), pp.7-12. ⟨10.1016/j.ifacol.2016.07.081⟩. ⟨hal-03669983⟩

• COMM

Using Discrete Event Simulation to evaluate Operating Theater Layout

Abdelahad Chraibi, Abdessamad Ait El Cadi, Said Kharraja, Abdelhakim Artiba

The layout planning of an organization is known to have a great impact on its quality and performance during daily operations. The Operating Theater (OT) is an organization characterized by a fluctuating production and unpredictability of care demand. This unpredictability of populations’ needs has...

IFAC-PapersOnLine, Jun 2016, Troyes, France. pp.95-98, ⟨10.1016/j.ifacol.2016.07.556⟩. ⟨hal-03383338⟩