Publicaciones

• Article dans une revue

Influence of roughness on ZDDP tribofilm formation in boundary lubricated fretting

K Kubiak, T Mathia, Maxence Bigerelle

Influence of initial surface topography on tribofilm formation in zinc dialkyldithiophosphate (ZDDP) lubricated contact was analysed. Small displacement fretting tests with sinusoidal motion were carried out in classical sphere/plane configuration. A range of surfaces with different initial...

Tribology - Materials, Surfaces & Interfaces, 2013, 6 (4), pp.182-188. ⟨10.1179/1751584X12Y.0000000020⟩. ⟨hal-04489098⟩

• Article dans une revue

Sterring Wheel Hand Position in Low-Speed Maneuvers

Jessica Schiro, François Gabrielli, Philippe Pudlo, Mohamed Djemai

The pattern of hand positioning varies considerably as drivers attempt to steer through sharp turns at low speed. The technique chosen by the driver should be the best compromise between car control and driver safety (i.e. airbag deployment). The purpose of this study was to assess different...

Transportation Research Part F: Traffic Psychology and Behaviour, 2013, 21, pp.133-145. ⟨10.1016/j.trf.2013.09.003⟩. ⟨hal-03508037⟩

• Article dans une revue

3D-MSCT imaging of bullet trajectory in 3D crime scene reconstruction: Two case reports

Thomas Colard, Yann Delannoy, François Bresson, Christophe Maréchal, Jean-Sébastien Raul, Valery Hedouin

Postmortem investigations are increasingly assisted by three-dimensional multi-slice computed tomography (3D-MSCT) and have become more available to forensic pathologists over the past 20 years. In cases of ballistic wounds, 3D-MSCT can provide an accurate description of the bullet location, bone...

Legal Medicine, 2013, 15 (6), pp.318-322. ⟨10.1016/j.legalmed.2013.07.002⟩. ⟨hal-03613687⟩

• Article dans une revue

Steering wheel hand position in low-speed maneuvers

Jessica Schiro, François Gabrielli, Philippe Pudlo, Mohamed Djemai, Franck Barbier

The pattern of hand positioning varies considerably as drivers attempt to steer through sharp turns at low speed. The technique chosen by the driver should be the best compromise between car control and driver safety (i.e. airbag deployment). The purpose of this study was to assess different...

Transportation Research Part F: Traffic Psychology and Behaviour, 2013, 21, pp.133-145. ⟨10.1016/j.trf.2013.09.003⟩. ⟨hal-03624787⟩

• Article dans une revue

Human-Centered Design strategy applied to the development of a system to support the entry of coded and structured medical information

Sylvain Hassler, Nicolas Leroy, Maxime Baas, César Boog, Séverine Loiseau, Madeleine Favre, Sylvia Pelayo

Coding medical records data is a key factor for an optimal use of software dedicated to physicians. Now, coding tools provided to physicians are rarely used because of ergonomics problems making their use arduous. Applying the User Centered Design approach to the development of this kind of tools...

Innovation and Research in BioMedical engineering, 2013, 34 (4-5), pp.259-262. ⟨10.1016/j.irbm.2013.09.003⟩. ⟨hal-03478733⟩

• Article dans une revue

Crosswalk time estimation and time perception: An experimental study among older female pedestrians

Janick Naveteur, Julie Delzenne, P. Sockeel, Eric Watelain, Marie-Agnes Dupuy

Since the sense of time is strongly influenced by advancing age, this laboratory study aimed to find out more about older pedestrians’ decisions to cross the road, focusing on their estimates of how long it would take them to cross. The walking times of older female adults with or without any...

Accident Analysis & Prevention, 2013, 60, pp.42--49. ⟨10.1016/j.aap.2013.08.014⟩. ⟨hal-01342237⟩

• Article dans une revue

Method for quantitative assessment of the domino effect in industrial sites

Farid Kadri, Eric Chatelet, Guangpu Chen

Accidents caused by the domino effect are the most destructive accidents related to industrial sites. The most typical primary incidents for a domino effect sequence are explosions (57%), followed by fires (43%). These former can generate three escalation vectors (heat load, overpressure, and...

Process Safety and Environmental Protection, 2013, 91 (6), pp.452-462. ⟨10.1016/j.psep.2012.10.010⟩. ⟨hal-02332123⟩

• Article dans une revue

Parametric Study of the Effect of the Vapor Chamber Characteristics on Its Performance

Hamdy Hassan, Souad Harmand

In this work, the effect of vapor chamber characteristics, the properties of its working fluid and the operating parameters on the vapor chamber performance are studied. Also, the effects of these parameters on the cooling process are considered. A three dimensional hydrodynamic model is used for...

Journal of Heat Transfer, 2013, 135 (11), pp.111008. ⟨10.1115/1.4024613⟩. ⟨hal-03615914⟩

• Article dans une revue

Special issue DSD 2012 on Reliability and dependability in MPSoC Technologies

Smail Niar, Cristina Silvano

Microprocessors and Microsystems: Embedded Hardware Design , 2013, 37 (8, PART A), pp.759. ⟨10.1016/j.micpro.2013.08.005⟩. ⟨hal-03624184⟩

• Article dans une revue

Friction analysis at the glass/tool interface and the lubrication influence during hot forming cycles

Philippe Moreau, Damien Montoya, Dominique Lochegnies, Hugues Vivier

In the hollow glass industry, specifically in the luxury perfume glass bottle industry, the success of the forming process depends on preventing the sticking at the glass/mold interface to make it easier to release the mold and prevent defects on the glass surface. This study concerns a new way to...

Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2013, 227 (11), pp.1253-1260. ⟨10.1177/1350650113488309⟩. ⟨hal-03621581⟩