Publications

• Chapitre d'ouvrage

Trois expériences d'apprentissage par les problèmes

Jean-Paul Becar, Jean-Charles Canonne, Fabrice Robert, Eric Cartignies, Aurel Fratu, Mariana Fratu, Désiré Dauphin Rasolomampionona

Le projet : les pratiques en IUT, Contribution au chapitre IV- Articuler l’approche projet et le pilotage institutionnel, L’Harmattan, pp.106-110, 2016, 978-2-343-10803-2. ⟨hal-02508572⟩

• Article dans une revue

Experimental Study of Heat and Mass Transfer for Liquid Film Evaporation along a Vertical Plate Covered With a Porous Layer

Amine Terzi, Sadok Ben Jabrallah, Souad Harmand

In this paper, we realized an Experimental study of heat and mass transfer for liquid evaporation along a vertical plate covered with a porous layer. To develop this study, an experimental dispositive was realized. To highlight the effect of the addition of a porous layer on the phenomenon of…

Journal of Applied Fluid Mechanics, 2016, Selected papers from the 7thInternational Exergy, Energy and Environment Symposium, IEEE7-2015, 9 (Special issue 1), pp.113-120. ⟨10.36884/jafm.9.SI1.25821⟩. ⟨hal-03447185⟩

• Article dans une revue

Local stability of discrete-time TS fuzzy systems

Zsofia Lendek, Jimmy Lauber

This paper considers local stability analysis of discrete-time Takagi-Sugeno fuzzy systems, for which classically in the TS literature only global stability is considered. Using a common quadratic and nonquadratic Lyapunov function, respectively, LMI conditions are developed to establish local…

IFAC-PapersOnLine, 2016, 49 (5), pp.7-12. ⟨10.1016/j.ifacol.2016.07.081⟩. ⟨hal-03669983⟩

• Article dans une revue

Multiscale roughness analysis of engineering surfaces: A comparison of methods for the investigation of functional correlations

Gaëtan Le Goïc, Maxence Bigerelle, Serge Samper, Hugues Favrelière, Maurice Pillet

This study investigates the correlations between the topography of different damaged rough surfaces and process conditions. Several surfaces are measured and compared to determine if they can be discriminated. The analysis is performed by using Gaussian Filtering, Wavelet Transform and a more…

Mechanical Systems and Signal Processing, 2016, 66-67, pp.437-457. ⟨10.1016/j.ymssp.2015.05.029⟩. ⟨hal-01202891⟩

• Article dans une revue

Experimental Investigations on Oscillatory Couette Taylor Flow Wall Shear Stress Behavior using Electrochemical Technique: Low Modulation Effect

Emna Berrich, Fethi Aloui, Jack M Legrand

In the simplest and original case of study of the Taylor–Couette TC problems, the fluid is contained between a fixed outer cylinder and a concentric inner cylinder which rotates at constant angular velocity. Much of the works done has been concerned on steady rotating cylinder(s) i.e. rotating…

Journal of Applied Fluid Mechanics, 2016, 9 (1), pp.147-154. ⟨10.36884/jafm.9.SI1.26163⟩. ⟨hal-02545268⟩

• Rapport

Pistes d’amélioration d’un siège d’avion pour passager à mobilité réduite

François Gabrielli, Philippe Pudlo

[Rapport de recherche] LAMIH, Valenciennes. 2016. ⟨hal-03420631⟩

• Chapitre d'ouvrage

Measurements of dynamic properties of ballistic yarns using innovative testing devices

Caroline Chevalier, Christophe Kerisit, Andreas Klavzar, François Boussu, Daniel Coutellier

This chapter highlights the influence of the dynamic characteristic of yarn on the ballistic performance of fabric submitted to impact. A brief review of existing research works done on the dynamic tensile test known as the Hopkinson bar, and more recently the Split Flying Bar, is presented. A new…

Advanced Fibrous Composite Materials for Ballistic Protection, Elsevier, pp.199-215, 2016, 978-178242461-1. ⟨10.1016/B978-1-78242-461-1.00007-8⟩. ⟨hal-03667392⟩

• Article dans une revue

Turbulent Plane Impinging Jet-Physical Insight and Turbulence Modeling

Mahmoud Charmiyan, Ahmed-Reza Azimian, Laurent Keirsbulck, Ebrahim Shirani, Fethi Aloui

A 3D numerical simulation using large eddy simulation (LES) method is performed for a submerged turbulent water slot jet impinging normally on a flat plate with a nozzle-to-plate distance of 10 jet width and a Reynolds number of 16000 and the results are compared with the existing experimental data…

Journal of Applied Fluid Mechanics, 2016, 9 (1), pp.11-17. ⟨10.36884/jafm.9.SI1.25825⟩. ⟨hal-03448221⟩

• Article dans une revue

Experimental study on the stability of an impedance-type force-feedback architecture based on an augmented-state observer for a haptic system under time delay using a LMI approach

Quoc Viet Dang, Laurent Vermeiren, Antoine Dequidt, Michel Dambrine

One of the most important performance measures of a haptic interface may be characterized by its behaviour in the implementation of a virtual wall in terms of the biggest value of the virtual stiffness that still leaves the device stable. This value depends on many factors including time delays and…

Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering, 2016, 230 (1), pp.58-71. ⟨10.1177/0959651815611566⟩. ⟨hal-03426981⟩

• Communication dans un congrès

Maintenance decision support for sustainable performance: problems and research directions at the crossroads of health management and eco-design

Olivier Sénéchal

Despite companies progressively taking sustainable performance into account through various governmental incentives and policies, most still have their own strategic, tactical or operational targets based essentially on economic criteria (turnover, productivity, inventory valuation...). Since the…

3rd IFAC Workshop on Advanced Maintenance Engineering, Services and Technology AMEST 2016, Oct 2016, Biarritz, France. pp.85-90, ⟨10.1016/j.ifacol.2016.11.015⟩. ⟨hal-03416145⟩