Reda Nouacer, Manel Djemal, Smail Niar, Gilles Mouchard, Nicolas Rapin, Jean-Pierre Gallois, Philippe Fiani, François Chastrette, Arnault Lapitre, Toni Adriano, Bryan Mac-Eachen

To support advanced features such as hybrid engine control, intelligent energy management, and advanced driver assistance systems, automotive embedded systems must use advanced technologies. As a result, systems are becoming distributed and include dozens of Electronic Control Units (ECU). On the…

Microprocessors and Microsystems: Embedded Hardware Design , 2016, 47, pp.252-261. ⟨10.1016/j.micpro.2016.07.020⟩. ⟨cea-01845196⟩

Article dans une revue

Robust speaker identification system over AWGN channel using improved features extraction and efficient SAD algorithm with prior SNR estimation

Riadh Ajgou, Salim Sbaa, Said Ghendir, Ali Chemsa, Abdelmalik Taleb-Ahmed

This paper motivates the combination of Autoregressive (AR) parameters and Mel Frequency Cepstral Coefficients (MFCC) features for remote robust text-independent speaker identification. All speaker identification techniques start by converting the raw speech signal into a sequence of acoustic…

International Journal of Circuits, Systems and Signal Processing, 2016, 10, pp.108-118. ⟨hal-03664850⟩

Article dans une revue

Experimental Study of Heat and Mass Transfer for Liquid Film Evaporation along a Vertical Plate Covered With a Porous Layer

Amine Terzi, Sadok Ben Jabrallah, Souad Harmand

In this paper, we realized an Experimental study of heat and mass transfer for liquid evaporation along a vertical plate covered with a porous layer. To develop this study, an experimental dispositive was realized. To highlight the effect of the addition of a porous layer on the phenomenon of…

Journal of Applied Fluid Mechanics, 2016, Selected papers from the 7thInternational Exergy, Energy and Environment Symposium, IEEE7-2015, 9 (Special issue 1), pp.113-120. ⟨10.36884/jafm.9.SI1.25821⟩. ⟨hal-03447185⟩

Article dans une revue

Local stability of discrete-time TS fuzzy systems

Zsofia Lendek, Jimmy Lauber

This paper considers local stability analysis of discrete-time Takagi-Sugeno fuzzy systems, for which classically in the TS literature only global stability is considered. Using a common quadratic and nonquadratic Lyapunov function, respectively, LMI conditions are developed to establish local…

IFAC-PapersOnLine, 2016, 49 (5), pp.7-12. ⟨10.1016/j.ifacol.2016.07.081⟩. ⟨hal-03669983⟩

Article dans une revue

Multiscale roughness analysis of engineering surfaces: A comparison of methods for the investigation of functional correlations

Gaëtan Le Goïc, Maxence Bigerelle, Serge Samper, Hugues Favrelière, Maurice Pillet

This study investigates the correlations between the topography of different damaged rough surfaces and process conditions. Several surfaces are measured and compared to determine if they can be discriminated. The analysis is performed by using Gaussian Filtering, Wavelet Transform and a more…

Mechanical Systems and Signal Processing, 2016, 66-67, pp.437-457. ⟨10.1016/j.ymssp.2015.05.029⟩. ⟨hal-01202891⟩

Article dans une revue

Experimental Investigations on Oscillatory Couette Taylor Flow Wall Shear Stress Behavior using Electrochemical Technique: Low Modulation Effect

Emna Berrich, Fethi Aloui, Jack M Legrand

In the simplest and original case of study of the Taylor–Couette TC problems, the ﬂuid is contained between a ﬁxed outer cylinder and a concentric inner cylinder which rotates at constant angular velocity. Much of the works done has been concerned on steady rotating cylinder(s) i.e. rotating…

Journal of Applied Fluid Mechanics, 2016, 9 (1), pp.147-154. ⟨10.36884/jafm.9.SI1.26163⟩. ⟨hal-02545268⟩

Article dans une revue

Relationship between brightness and roughness of polypropylene abraded surfaces

Adrien van Gorp, Maxence Bigerelle, Denis Najjar

This article proposes to analyze the relation between gloss and roughness of surfaces of polypropylene samples abraded at different magnitudes. Experiments consist of mechanical polishing at different grades, roughness profiles measurement, and specular light reflectometry with three incidence…

Polymer Engineering and Science, 2016, 56 (1), pp.103 - 117. ⟨10.1002/pen.24197⟩. ⟨hal-04530473⟩

Article dans une revue

Relationship between brightness and roughness of polypropylene abraded surfaces

Adrien van Gorp, Maxence Bigerelle, Denis Najjar

This article proposes to analyze the relation between gloss and roughness of surfaces of polypropylene samples abraded at different magnitudes. Experiments consist of mechanical polishing at different grades, roughness profiles measurement, and specular light reflectometry with three incidence…

Polymer Engineering and Science, 2016, 56 (1), pp.103 - 117. ⟨10.1002/pen.24197⟩. ⟨hal-04530638⟩