Publications

• Article dans une revue

Steering wheel hand position in low-speed maneuvers

Jessica Schiro, François Gabrielli, Philippe Pudlo, Mohamed Djemai, Franck Barbier

The pattern of hand positioning varies considerably as drivers attempt to steer through sharp turns at low speed. The technique chosen by the driver should be the best compromise between car control and driver safety (i.e. airbag deployment). The purpose of this study was to assess different…

Transportation Research Part F: Traffic Psychology and Behaviour, 2013, 21, pp.133-145. ⟨10.1016/j.trf.2013.09.003⟩. ⟨hal-03624787⟩

• Article dans une revue

Crosswalk time estimation and time perception: An experimental study among older female pedestrians

Janick Naveteur, Julie Delzenne, P. Sockeel, Eric Watelain, Marie-Agnes Dupuy

Since the sense of time is strongly influenced by advancing age, this laboratory study aimed to find out more about older pedestrians’ decisions to cross the road, focusing on their estimates of how long it would take them to cross. The walking times of older female adults with or without any…

Accident Analysis & Prevention, 2013, 60, pp.42--49. ⟨10.1016/j.aap.2013.08.014⟩. ⟨hal-01342237⟩

• Article dans une revue

Method for quantitative assessment of the domino effect in industrial sites

Farid Kadri, Eric Chatelet, Guangpu Chen

Accidents caused by the domino effect are the most destructive accidents related to industrial sites. The most typical primary incidents for a domino effect sequence are explosions (57%), followed by fires (43%). These former can generate three escalation vectors (heat load, overpressure, and…

Process Safety and Environmental Protection, 2013, 91 (6), pp.452-462. ⟨10.1016/j.psep.2012.10.010⟩. ⟨hal-02332123⟩

• Article dans une revue

Special issue DSD 2012 on Reliability and dependability in MPSoC Technologies

Smail Niar, Cristina Silvano

Microprocessors and Microsystems: Embedded Hardware Design , 2013, 37 (8, PART A), pp.759. ⟨10.1016/j.micpro.2013.08.005⟩. ⟨hal-03624184⟩

• Article dans une revue

Parametric Study of the Effect of the Vapor Chamber Characteristics on Its Performance

Hamdy Hassan, Souad Harmand

In this work, the effect of vapor chamber characteristics, the properties of its working fluid and the operating parameters on the vapor chamber performance are studied. Also, the effects of these parameters on the cooling process are considered. A three dimensional hydrodynamic model is used for…

Journal of Heat Transfer, 2013, 135 (11), pp.111008. ⟨10.1115/1.4024613⟩. ⟨hal-03615914⟩

• Article dans une revue

Friction analysis at the glass/tool interface and the lubrication influence during hot forming cycles

Philippe Moreau, Damien Montoya, Dominique Lochegnies, Hugues Vivier

In the hollow glass industry, specifically in the luxury perfume glass bottle industry, the success of the forming process depends on preventing the sticking at the glass/mold interface to make it easier to release the mold and prevent defects on the glass surface. This study concerns a new way to…

Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2013, 227 (11), pp.1253-1260. ⟨10.1177/1350650113488309⟩. ⟨hal-03621581⟩

• Article dans une revue

Effects of synchronous versus asynchronous mode of propulsion on wheelchair basketball sprinting.

Arnaud Faupin, Benoît Borel, Christophe Meyer, Philippe Gorce, Eric Watelain

This study aimed to first investigate synchronous (SYN) versus asynchronous (ASY) mode of propulsion and, second, investigate the wheel camber effects on sprinting performance as well as temporal parameters. Seven wheelchair basketball players performed four maximal eight-second sprints on a…

Disability and Rehabilitation: Assistive Technology, 2013, 8 (6), pp.496-501. ⟨10.3109/17483107.2012.756947⟩. ⟨hal-01145760⟩

• Article dans une revue

Turbulent impinging jet flow into an unshrouded rotor-stator system: Hydrodynamics and heat transfer

Sébastien Poncet, Thien Duy Nguyen, Souad Harmand, Julien Pellé, Riccardo da Soghe, Cosimo Bianchini, Stéphane Viazzo

New calculations using an innovative Reynolds Stress Model are compared to velocity measurements performed by Particle Image Velocimetry technique and the predictions of a k-w SST model in the case of an impinging jet flow onto a rotating disk in a discoidal and unshrouded rotor-stator system. The…

International Journal of Heat and Fluid Flow, 2013, 44, pp.719-734. ⟨10.1016/j.ijheatfluidflow.2013.10.001⟩. ⟨hal-00976669⟩

• Article dans une revue

Wall shear stress characterization of a 3D bluff-body separated flow

Grégoire Fourrié, Laurent Keirsbulck, Larbi Labraga

Efficient flow control strategies aimed at reducing the aerodynamic drag of road vehicles require a detailed knowledge of the reference flow. In this work, the flow around the rear slanted window of a generic car model was experimentally studied through wall shear stress measurements using an…

Journal of Fluids and Structures, 2013, 42, pp.55-69. ⟨10.1016/j.jfluidstructs.2013.05.014⟩. ⟨hal-03615070⟩

• Article dans une revue

Experimental study of two-phase flow pattern evolution in a horizontal circular tube of small diameter in laminar flow conditions

S. Zeguai, Soufien Chikh, L. Tadrist

The carried out experimental study aims at analyzing air-water two-phase flow patterns in a horizontal tube for laminar flow with carefully controlled conditions. An experimental test rig has been setup to produce a two-phase flow in a glass tube of 3 mm inner diameter with co-current air and water…

International Journal of Multiphase Flow, 2013, 55, pp.99-110. ⟨10.1016/j.ijmultiphaseflow.2013.04.008⟩. ⟨hal-01459472⟩