Publications

• Article dans une revue

Exergy assessment of heat transfer inside a Beta type Stirling engine

Houda Hachem, Ramla Gheith, Fethi Aloui, Sassi Ben Nasrallah, Ibrahim Dincer

This paper presents an assessment of both energy and exergy efficiencies of a Beta Stirling engine prototype with a 30 W capacity as the maximum mechanical power output. Its operating pressure is close to atmospheric pressure, and it supports a maximum hot end temperature of 650 degrees C. The…

International Journal of Exergy, 2016, 20 (2), pp.186-202. ⟨10.1504/IJEX.2016.076863⟩. ⟨hal-03447147⟩

• Article dans une revue

Finding a stabilizing switching law for switching TS models

Zsofia Lendek, Paula Raica, Jimmy Lauber, Thierry-Marie Guerra

This paper considers the stabilisation of switching nonlinear models by switching between the subsystems. We assume that arbitrary switching between two subsystems is possible once a subsystem has been active for a predefined number of samples. We use a Takagi–Sugeno representation of the models…

International Journal of Systems Science, 2016, 47 (12), pp.2762-2772. ⟨10.1080/00207721.2015.1021290⟩. ⟨hal-03430042⟩

• Communication dans un congrès

Advanced model based air path management using a discrete-angular controller in idle-speed context

Thomas Laurain, Jimmy Lauber, Reinaldo Martinez Palhares

This paper aims to present an original methodology to design a controller for the air path management considered as a nonlinear system that is presented as a periodic discrete Takagi-Sugeno (TS) model. A transformation is realized to translate the periodic behavior into a classic discrete model…

IFAC AAC, Jun 2016, Norkköping, Sweden. pp.611-618, ⟨10.1016/j.ifacol.2016.08.089⟩. ⟨hal-03407068⟩

• Communication dans un congrès

An Iterative Greedy Insertion Technique for Flexible Job Shop Scheduling Problem

Azzedine Bekkar, Oualid Guemri, Abdelghani Bekrar, Nassima Aissani, Bouziane Beldjilali, Damien Trentesaux

This paper studies the problem of scheduling in a flexible job shop. A greedy heuristic is developed to solve precisely the sequencing (allocation) problem. The principle of this approach is to iteratively insert operations on the machines until the objective of minimizing the Cmax (makespan) is…

8th IFAC Conference on Manufacturing Modelling, Management and Control MIM 2016, Dec 2016, Troyes, France. pp.1956-1961, ⟨10.1016/j.ifacol.2016.07.917⟩. ⟨hal-03406967⟩

• Ouvrages

Special issue: Information Systems in Transport Logistics, International Journal of Shipping and Transport Logistics

Mounir Benaissa, Mourad Abed

Inderscience Publishers, 2016, 1756-6517. ⟨hal-03388662⟩

• Communication dans un congrès

HCI Engineering Integrated with Capability Maturity Models

Taisa Guidini Gonçalves, Káthia Marçal de Oliveira, Christophe Kolski

Even though coming from different communities, Software Engineering (SE) and Human-Computer Interaction (HCI) engineering have similar goals: the definition of methods, techniques and standards to support the development of software systems, and, in particular for HCI, of interactive systems.…

10th International Conference on Research Challenges in Information Science, IEEE RCIS 2016, Institute of Electrical and Electronics Engineers (IEEE), May 2016, Grenoble, France. pp.633-644, ⟨10.1109/RCIS.2016.7549319⟩. ⟨hal-03350385⟩

• Article dans une revue

A new reduced model of scavenging to optimize cylinder design

Stéphanie Cagin, Xavier Fischer, Eric Delacourt, Nachida Bourabaa, Céline Morin, Daniel Coutellier, Bertrand Carre, Sylvain Loumé

This paper presents the development of a new scavenging model to optimize cylinder design. The developed model explicitly integrates some of the cylinder’s design and environmental variables to describe flows during the scavenging process. Then, based on the reduced model, an optimization phase was…

SIMULATION: Transactions of The Society for Modeling and Simulation International, 2016, 92 (6), pp.507-520. ⟨10.1177/0037549716644516⟩. ⟨hal-01330975⟩

• Chapitre d'ouvrage

Measurements of dynamic properties of ballistic yarns using innovative testing devices

Caroline Chevalier, Christophe Kerisit, Andreas Klavzar, François Boussu, Daniel Coutellier

This chapter highlights the influence of the dynamic characteristic of yarn on the ballistic performance of fabric submitted to impact. A brief review of existing research works done on the dynamic tensile test known as the Hopkinson bar, and more recently the Split Flying Bar, is presented. A new…

Advanced Fibrous Composite Materials for Ballistic Protection, Elsevier, pp.199-215, 2016, 978-178242461-1. ⟨10.1016/B978-1-78242-461-1.00007-8⟩. ⟨hal-03667392⟩

• Chapitre d'ouvrage

Arezzo: an emulator for the bench4star initiative

Thierry Berger, Dominique Deneux, Thérèse Bonte, Etienne Cocquebert, Damien Trentesaux

Fischer X., Daidie A., Eynard B., Paredes M. Research in Interactive Design, 4, Springer, pp. 530-536, 2016, 978-3-319-26119-5. ⟨hal-03406808⟩

• Article dans une revue

Increased antagonist muscle activity in cervical SCI patients suggests altered reciprocal inhibition during elbow contractions

Sylvain Cremoux, David Amarantini, Jessica Tallet, Fabien Dal Maso, Eric Berton

Objective: After spinal cord injury (SCI), the antagonist muscles activation is increased during voluntary contractions and reflex conditioning protocols. This increase can be the result of both muscle atrophy and reciprocal facilitation mechanism. It remains however unclear to what extent…

Clinical Neurophysiology, 2016, 127 (1), pp.629-634. ⟨10.1016/j.clinph.2015.03.016⟩. ⟨hal-01454735⟩