Publications

• Chapitre d'ouvrage

Technical and Economic Analysis of Ionic Liquid-Based Post-combustion CO2 Capture Process

Baptiste Zacchello, Eni Oko, Meihong Wang, Fethi Aloui

Post-combustion CO2 capture (PCC) is considered the most feasible and viable process for CO2 abatement in the power sector. Aqueous monoethanolamine (MEA) solvent, traditionally used in this process, brings along challenges, namely, huge energy requirement for solvent regeneration, huge solvent…

Exergy for A Better Environment and Improved Sustainability 1, Springer International Publishing, pp.1393-1411, 2018, Green Energy and Technology, ⟨10.1007/978-3-319-62572-0_89⟩. ⟨hal-03677137⟩

• Chapitre d'ouvrage

Modeling Energetic Efficiency of Coil Annealing Using Hydrogen Gas

Abdallah Haouam, Maxence Bigerelle, Bachir Merzoug

Determining the temperature of several steel coils, heated in a furnace traversed by hydrogen, is approached by numerical modeling using differential equations governing heat transfers involved. The resolution is performed by the method of finite differences. Convergence standards of different…

Exergy for A Better Environment and Improved Sustainability 1, Springer International Publishing, pp.289-302, 2018, Green Energy and Technology, ⟨10.1007/978-3-319-62572-0_20⟩. ⟨hal-03675351⟩

• Chapitre d'ouvrage

Recovery of Waste Farm After Methanation by Evaporation on Inclined Plate

Hiba Zouaghi, Souad Harmand, Sadok Ben Jabrallah

This work addresses the recovery of a liquid effluent by thermal evaporation. It is a digestate of pig manure, rich in N, P, and K (Granier et al. 1995; Latimier et al. 1996; Levasseur, TECHNI 21(4):16–19, 1998). The effluent was subjected to anaerobic digestion and phase separation by…

Exergy for A Better Environment and Improved Sustainability 1, Springer International Publishing, pp.645-660, 2018, Green Energy and Technology, ⟨10.1007/978-3-319-62572-0_42⟩. ⟨hal-03677159⟩

• Article dans une revue

On the modeling of a visco-hyperelastic polymer gel under blunt ballistic impacts

Anthony Bracq, Grégory Haugou, Benjamin Bourel, Christophe Maréchal, Franck Lauro, Sébastien Roth, Olivier Mauzac

In this paper, the modeling of a polymer gel used as target medium in blunt ballistic experiments is presented. A new visco-hyperelastic law based on the Mooney–Rivlin model is proposed and implemented in a numerical simulation software. The material model identification relies on mechanical…

International Journal of Impact Engineering, 2018, 118, pp.78-90. ⟨10.1016/j.ijimpeng.2018.04.001⟩. ⟨hal-03451027⟩

• Ouvrages

ASAASIT: Architectures and Systems for Automotive, Aeronautic, Space and Intelligent Transportation

Smail Niar, Ihsen Alouani

Digital systems in intelligent transportation systems (ITS) will play an important role and are becoming increasingly complex. New applications for these ITS have emerged to respond to people and societal needs and to ensure driver and passenger safety. Applications such as Driverless cars, Vehicle…

2018. ⟨hal-03403063⟩

• Communication dans un congrès

Lattice Boltzmann Model for Incompressible Axisymmetric Thermal Flows With Swirl

Insaf Mehrez, Ramla Gheith, Fethi Aloui, Samia Ben Nasrallah

This paper presents a Lattice Boltzmann (LB) model for incompressible axisymmetric thermal flows. The forces and source terms are added into the Lattice Boltzmann Equation (LBE) and the incompressible Navier-Stokes equations are recovered by the Chapman-Enskog expansion. The model of Zhou [1] is…

ASME 2018 5th Joint US-European Fluids Engineering Division Summer Meeting, Jul 2018, Montreal, Canada. ⟨10.1115/FEDSM2018-83337⟩. ⟨hal-03676498⟩

• Communication dans un congrès

Dynamic Parking Allocation Problem in urban areas

Marko Mladenovic, Thierry Delot, Gilbert Laporte, Christophe Wilbaut

29th European Conference on Operational Research, Jul 2018, Valencia, Spain. ⟨hal-03383148⟩

• Article dans une revue

INFLUENCE OF THE BONE MORPHOLOGY ON MECHANICAL BEHAVIOR OF HUMAN SKULL FOR TWO STRAIN RATE CASES

Manaf Karkar, Christophe Maréchal, Rémi Delille, Grégory Haugou, François Bresson, Pascal Drazetic, Thomas Colard

Modeling the mechanical behavior of bone is very complex due to substantial variability of the mechanical response of bone. The objective of this study is to investigate the link between morphology of the human parietal bone and its mechanical behavior in compression with two different strain rates…

Journal of Mechanics in Medicine and Biology, 2018, 18 (4), pp.1850046. ⟨10.1142/S021951941850046X⟩. ⟨hal-03450088⟩

• Article dans une revue

Numerical optimization of cell colonization modelling inside scaffold for perfusion bioreactor: A multiscale model

T-K. Nguyen, Olivier Carpentier, Francine Monchau, F. Chai, Jean-Christophe Hornez, Ph. Hivart

Part of clinically applicable bone graft substitutes are developed by using mechanical stimulation of flow-perfusion into cell-seeded scaffolds. The role of fluid flow is crucial in driving the nutrient to seeded cells and in stimulating cell colonization. A common numerical approach is to use a…

Medical Engineering & Physics, 2018, 57, pp.40-50. ⟨10.1016/j.medengphy.2018.04.012⟩. ⟨hal-03080599⟩

• Article dans une revue

Virtual strain gauge based on a fuzzy discrete angular domain observer: Application to engine and clutch torque estimation issues

Rémi Losero, Jimmy Lauber, Thierry-Marie Guerra

In many real time applications, information of transmitted torque is a mandatory input of the embedded control strategies. In the most of cases, the use of a physical torque sensor (strain gauge) is compromised by cost and bulk reasons and the torque is not measured. Unfortunately, the need of an…

Fuzzy Sets and Systems, 2018, 343, pp.76-96. ⟨10.1016/j.fss.2018.02.016⟩. ⟨hal-03428137⟩